workgroup:connectors:start
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
workgroup:connectors:start [2017/04/24 18:21] Lorenz Meier [Archived] |
workgroup:connectors:start [2017/07/26 05:37] Lorenz Meier |
||
|---|---|---|---|
| Line 21: | Line 21: | ||
| * [[http://www.jst-mfg.com/product/detail_e.php?series=105|JST GH Series]] | * [[http://www.jst-mfg.com/product/detail_e.php?series=105|JST GH Series]] | ||
| + | |||
| ==== Pinouts ==== | ==== Pinouts ==== | ||
| === Telemetry Port === | === Telemetry Port === | ||
| - | This pinout should be used for any serial port. Ports not supporting hardware flow control should leave the CTS and RTS lines floating. | + | This pinout should be used for any serial port. Ports not supporting hardware flow control should leave the CTS and RTS lines floating. Cables should be 1:1 to the periphal and TX / RX should be crossed on the peripheral side (e.g. a radio modem would have its RX port on pin 2 and TX port on pin 3). |
| ^ Pin ^ Signal ^ Volt ^ | ^ Pin ^ Signal ^ Volt ^ | ||
workgroup/connectors/start.txt ยท Last modified: 2021/02/23 03:04 by Ramon Roche
Page Tools
