This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
workgroup:connectors:start [2017/07/26 05:38] Lorenz Meier |
workgroup:connectors:start [2017/07/26 06:17] Lorenz Meier |
||
---|---|---|---|
Line 26: | Line 26: | ||
==== Telemetry Port ==== | ==== Telemetry Port ==== | ||
- | This pinout should be used for any serial port. Ports not supporting hardware flow control should leave the CTS and RTS lines floating. Cables should be 1:1 to the periphal and TX / RX should be crossed on the peripheral side (e.g. a radio modem would have its RX port on pin 2 and TX port on pin 3). | + | This pinout should be used for any serial port. Ports not supporting hardware flow control should leave the CTS and RTS lines floating. Cables should be 1:1 to the periphal and TX / RX as well as CTS / RTS should be crossed on the peripheral side (e.g. a radio modem would have its RX port on pin 2, TX port on pin 3, RTS on port 4 and CTS on port 5). |
^ Pin ^ Signal ^ Volt ^ | ^ Pin ^ Signal ^ Volt ^ |