This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
workgroup:connectors:start [2019/06/26 05:29] Hamish Willee Rename to Pixhawk Autopilot connector standard |
workgroup:connectors:start [2021/02/23 03:04] (current) Ramon Roche Clarify the connector standard and update links |
||
---|---|---|---|
Line 3: | Line 3: | ||
====== Pixhawk Autopilot Connector Standard ====== | ====== Pixhawk Autopilot Connector Standard ====== | ||
- | The [[https://pixhawk.org/pixhawk-connector-standard|Pixhawk Autopilot Connector Standard]] is documented on Pixhawk.org. | + | The Pixhawk connector standard is intended for in-vehicle, cross-PCB use. It uses the JST GH series, which offers a latch lock mechanism at a small size and a very competitive cost, and it's used across multiple Pixhawk Standards as the default connector. |
+ | |||
+ | |||
+ | The Pixhawk Autopilot Connector Standard is documented as part of the [[https://pixhawk.org/standards/|Pixhawk Reference Standards]] and is referred to as the official Pixhawk DS-009 Standard, the latest up to date version can be found on GitHub. | ||
+ | |||
+ | * [[https://github.com/pixhawk/Pixhawk-Standards/blob/master/DS-009%20Pixhawk%20Connector%20Standard.pdf|DS-009 Pixhawk Connector Standard]] (GitHub) | ||
+ | |||
+ | > Note, this was originally referred to as the "Dronecode Autopilot Connector Standard." | ||
+ | |||
- | > Note, this was originally referred to as the "Dronecode Autopilot Connector Standard". |